General; Power Switch; Ma Chine´s Safety Equipment; Emergency Stop - Husqvarna PP65 Manual De Instrucciones

General

W ARNING! Never use a machine that has
!
faulty safety equipment! If your machine
fails any checks contact your service
agent to get it repaired.
This section descr ibes the machine ' s safety equipment,
its purpose, and how checks and maintenance should be
carried out to ensure that it operates correctly.
This machine is used in combination with other products.
Please read the manual provided with the products
carefully and make sure you understand the instructions
before using the machine.
• Connect the power unit to a grounded outlet
• Connect the tool to be used.
P ower switch
The po wer switch is to be used to turn on and off power to
the tool.
Chec king the power switch
• Turn the switch to the OFF position (O).
• Make sure the tool cannot be started.
• Turn the switch to the ON position (I).
• Make sure the tool can be started.
6 – English
MA CHINE´S SAFETY EQ UIPMENT
Emer gency stop
The emergency stop on the unit slo ws the connected tool
and disconnects it from the power supply.
T esting the emergency stop
• Check that the emergency stop button is not pressed
by turning it clockwise.
• Turn the switch to the ON position (I).
• Start the connected tool.
• Press the emergency stop and check that the
connected tool stops.

Gr ound fault circuit interrupter

A residual-current de vice is fitted to protect operators in
case an electrical fault should occur.
Chec k the ground fault circuit interrupter
(Applies to 3-phase only)
• Connect the power unit to a grounded 3-phase outlet.
• Open the cover on the residual-current device to
access the switch (1) and test button (2).
• Set the control in the residual-current device in
position 1.
• Press the test button. The residual-current device
must trigger to disconnect the unit from the power
supply.
• Reset the residual-current device by first setting the
switch to 0 and then to 1.
• Refit and tighten the cover.
The residual-current device must be tested every two
weeks with the test button.