Assembly And Installation; Assembling The Metering Pump - ProMinent dulco flex DF2a Manual De Instrucciones

Assembly and installation

26
6 Assembly and installation
CAUTION
• It is not permitted to assemble and install this device with
non-ProMinent parts unless these have been tested and
recommended by ProMinent. May otherwise result in injury
to persons or property for which ProMinent will accept no
liability.
TAKE CARE
• The device is resistant against normal atmospheres in
technical areas.
• The device may not be used outdoors without additional
protection (outer casing, weatherproof cover). The
enclosure rating does not apply if the seals are subjected to
damp and direct sunlight can cause the housing to degrade.
• Installation must comply with relevant national directives.
6.1

Assembling the metering pump

Firstly remove the wall bracket from the device. It is used as a
drilling template
Attach the wall bracket to a wall or panel
Hang the device at the top into the wall/pipe mount
lightly at the bottom against the wall/pipe mount
upwards until you hear it latching into position
1
3
Fig. 2
3
and press
. Then press
.
2
ProMinent ®