Settings; Changing Direction Of Rotation [1-5]; Changing Gear [1-4]; Adjusting Torque - Festool CXS Manual De Instrucciones

Consider the pictures on the fold-out page.
CAUTION
Risk of injury

Always switch off the power tool before adjusting

settings!

Changing direction of rotation [1-5]

• Switch to the left = clockwise rotation
• Switch to the right = counterclockwise rotation

Changing gear [1-4]

• Gear switch forwards (digit 1 visible) = 1st gear
• Gear switch to rear (digit 2 visible) = 2nd gear
WARNING
Risk of injury

Always disconnect the battery pack before per-
forming any type of work on the machine!
CAUTION
Hot and sharp tools
Risk of injury

Do not use insert tools that are blunt or defec-
tive.

Wear protective gloves.
Settings
By turning the torque thumbwheel [1-2] the re-
quired torque can be adjusted. The arrow [1-3]
aligns with the adjusted state.
Drilling
Turn the torque thumbwheel [1-2] so that its
marking [1-3] faces the drilling symbol [1-1]. Max-
imum torque is set in this position.
Fastening
Adjust the torque accordingly at the torque thumb-
wheel [1-2]:
Position 1 = low torque
Position 12 = high torque
The machine switches off when the present torque
is reached. The machine only continues running
when the on/off switch [1-6] is released and
pressed again.

Tool holder, attachments

The tool chuck CENTROTEC WH-CE allows you to
change tools with a CENTROTEC shank in a matter
of seconds.
 Always use a CENTROTEC tool chuck to clamp
CENTROTEC tools.
Attaching the CENTROTEC
6

Adjusting torque

Tool chuck CENTROTEC WH-CE

6-3
6-2
6-1
6-4
13