Dolmar TM-98.14 H2D Manual De Instrucciones página 126

EN 28
5.4.10 C
ARD PROTECTION DEVICE
The electronic card has a self-resetting protector which breaks the circuit if there
is a fault in the electrical system. It results in the stopping of the engine and the
lighting up of the lamp.
The circuit automatically resets after a few seconds but the cause of the fault
should be ascertained and dealt with to avoid reactivating the protection device.
IMPORTANT
– do not reverse the leads on the battery terminals;
– do not use the machine without its battery or damage may be caused to the
charging regulator;
– be careful not to cause short-circuits.
5.4.11 S
UMMARY OF THE MAIN ACTIONS TO BE CARRIED OUT WHEN USING THE MACHINE
To ...
Start the engine (☛ 5.4.1)
Go forward (☛ 5.4.2)
Brake or stop (☛ 5.4.3)
Reverse (☛ 5.4.4)
Cut the grass (☛ 5.4.5)
To avoid activating the protection device.
You will need to ...
Open the fuel stopcock, ensure that all the conditions
allowing starting are met, and then turn the key.
Move the accelerator;
➤
for mechanical drive models: push the pedal right
down, engage the gear (☛ 4.22) and then gradually
release the pedal;
➤
for hydrostatic drive models: press the drive pedal for-
ward; (☛ 4.32);
Reduce the engine speed and press the brake pedal.
Stop the machine;
➤
for mechanical drive models: put into neutral (N), push
the pedal right down, engage reverse, (☛ 4.22) and
then gradually release the pedal;
➤
for hydrostatic drive models: press the drive pedal
back (☛ 4.32).
Move the accelerator; engage the blades and adjust the
cutting height.
➤
for mechanical drive models: push the pedal right
down, engage the gear (☛ 4.22) and then gradually
release the pedal;
➤
for hydrostatic drive models: press the drive pedal for-
ward; (☛ 4.32);
HOW TO USE THE MACHINE