En 24 How To Use The Machine - Dolmar TM-98.14 H2D Manual De Instrucciones

EN 24
5.4.4 R
EVERSE
Reverse must be engaged ONLY when the machine is stopped.
➤
For mechanical drive models:
Push down the pedal until the machine stops and then go into reverse by
moving the lever sideways and putting it into position «R» (☛ 4.22). Gradually
release the pedal to engage the clutch and then begin moving in reverse.
➤
For hydrostatic drive models:
When the machine is stopped, start the reverse movement by pressing the
drive pedal in the «R» direction (☛ 4.32).
5.4.5 G
RASS CUTTING
When you have reached the area to be mowed, make sure that the cutting deck
wheels are positioned at the required height.
Each wheel can be fitted at two different heights: the low position always leaves
a space between the ground and the
edge of the cutting deck to prevent the
deck from damaging the lawn if the
ground is uneven. The higher position
excludes this possibility.
To change the position unscrew and
remove the pin (1) then reposition the
wheel (2) in the upper and lower hole of
the wale corresponding to the wheel
diameter.
WARNING!
!
ENGINE OFF AND THE BLADES DISENGAGED.
To start cutting:
– put the accelerator into the «FAST» position;
– bring the cutting deck to the highest position;
This work is to be done to both wheels, WITH THE
HOW TO USE THE MACHINE
Ø 100
Ø 80
2
1