Dolmar TM-98.14 H2D Manual De Instrucciones página 121

HOW TO USE THE MACHINE
➤
For mechanical drive models:
Put the accelerator control between the «SLOW» and «FAST» positions, and
the gear change lever in the 1st speed position (☛ 4.22).
Keep the pedal pressed down and disengage the parking brake. Slowly
release the pedal which will turn from «brake» to «clutch», thus operating the
rear wheels (☛ 4.21).
WARNING!
!
engagement may cause tipping up and loss of control of the vehicle.
Gradually reach the desired operating speed using the accelerator and gear
lever. To change the gear speed the clutch must be used pushing the pedal
half way down (☛ 4.21).
➤
For hydrostatic drive models:
When moving the machine from one area to another, put the accelerator lever
in a midway position between «SLOW» and «FAST».
Disengage the parking brake and release the brake pedal (☛ 4.31).
Press the drive pedal (☛ 4.32) in direction »F» and reach the required speed
by progressively increasing pressure on the pedal and moving the accelerator
appropriately.
WARNING!
!
( ☛ 4.32) to prevent sudden engagement from causing tipping up and loss
of control of the vehicle, particularly on slopes.
5.4.3 B
RAKING
First, reduce the machine's speed by reducing the engine's r.p.m. and then push
the brake pedal (☛ 4.21 or 4.31) to further reduce the speed until the machine
stops.
➤
For hydrostatic drive models:
NOTE
releasing the drive pedal.
The pedal has to be released gradually as a sudden
Drive must be engaged in the way already described
The machine already slows down considerably by just
EN 23