En 22 How To Use The Machine - Dolmar TM-98.14 H2D Manual De Instrucciones

Ocultar thumbs Ver también para TM-98.14 H2D:
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

EN 22
– if the engine is already warm, just put the lever between «SLOW» and «FAST»;
– put in the key and turn to «ON» to make electrical contact, then turn to
«START» to start the engine;
– release the key once the engine has started.
When the engine has started, put the accelerator in the «SLOW» position.
IMPORTANT
smoothly. Using it when the engine is already warm can foul the spark plugs
and cause the engine to run erratically.
NOTE
smoothly. Using it when the engine is already warm can foul the spark plugs
and cause the engine to run erratically. Turn the key to the «OFF» position, wait
for a few seconds and then repeat the operation. If the malfunction continues,
refer to chapter «7» of this manual and to the engine manual.
IMPORTANT
engine from starting if safety requirements have not been met ( ☛ 5.2).
In these cases, once the situation has been corrected, the key must first be
turned back to «OFF» before the engine can be restarted.
5.4.2 S
TARTING AND MOVING WITHOUT MOWING
WARNING!
!
roads. It has to be used (as indicated by the highway code) in private
areas closed to traffic.
NOTE
and the cutting deck put at its highest position (position «7»).
The choke must be closed as soon as the engine is running
The choke must be closed as soon as the engine is running
Always bear in mind that the safety devices prevent the
This machine has not been approved for use on public
When moving the machine, the blades must be disengaged
HOW TO USE THE MACHINE
Tabla de contenido
loading

Tabla de contenido