Dolmar TM-98.14 H2D Manual De Instrucciones página 123

HOW TO USE THE MACHINE
– engage the blades (☛ 4.9);
– start moving forwards onto the grass area very gradually and with particular
caution, as already described;
– adjust the forward speed and the cutting height (☛ 4.8) according to the lawn
condition (height, density and dampness of the grass). On flat ground, these
general conditions can be followed:
High and dense grass - wet lawn
Average condition grass
Low grass - dry lawn
➤
For hydrostatic drive models:
The speed is controlled in a gradual and progressive way by the pressure on
the drive pedal.
WARNING!
!
must be reduced to ensure safe conditions ( ☛ 1.2 - 5.5).
In any case, the speed should always be lowered if you note a reduction in
engine speed, since a forward speed that is too fast compared to the amount of
grass being cut will never mow the grass well.
Disengage the blades and put the cutting deck in the highest position whenever
you need to get past an obstacle.
5.4.6 E
ND OF MOWING
When you have finished mowing, disengage the blades, lower the engine speed
and ride the machine with the cutting deck in the highest position.
5.4.7 E
ND OF WORK
Stop the machine, put the accelerator lever in the «SLOW» position and turn off
When cutting on sloping ground, the forward speed
2 km/h
3,5 ... 5,5 km/h
over 5,5 km/h
EN 25