Stihl RMI 422 P Manual De Instrucciones página 76

English
Always activate the disabling device before carrying out any inspection, cleaning or maintenance.
Condition
Docking not working.
The robotic mower travels past
the docking station or docks at an
angle.
The robotic mower has crossed
the perimeter wire.
The robotic mower frequently
becomes stuck.
Impact sensor is not activated
when the robotic mower hits an
obstacle.
74
Possible Cause
Docking station not connected to
power supply.
Incorrect docking.
Charging contacts corroded.
Uneven entry area to docking
station.
Dirty drive wheels or dirty base
plate.
Perimeter wire incorrectly routed
in area of docking station.
Ends of perimeter wire not cut.
Wire signal affected.
Perimeter wire incorrectly routed
in area of docking station.
Perimeter wire incorrectly routed,
clearances are not correct.
Slope of mowing area too steep. ► Check the clearances with the iMow Ruler, @ 11.3.
Interference affecting the robotic
mower.
Cutting height too low.
Drive wheels dirty.
Depressions or obstacles in the
mowing area.
Low obstacle (height less than
3.9 in. (10 cm)).
Remedy
► Check power supply to the docking station, @ 10.3.
► Place the robotic mower in the mowing area and
send it back to the docking station (@ 14.3), check
for correct docking. If necessary, correct the position
of the docking station,@ 10.3.
► Have the charging contacts replaced by an
authorized STIHL iMow servicing dealer.
► Level out the entry area to the docking station,
@ 14.3.
► Clean the drive wheels and the base plate of the
docking station, @ 19.
► Re-route the perimeter wire. Ensure correct routing
in the area of the docking station, @ 11.
► Cut the perimeter wire as described and route it
without excess length. Do not roll up protruding
ends, @ 10.5.
► Link the robotic mower and docking station again.
Ensure that the robotic mower is in correct
alignment to the docking station.
► Re-route the perimeter wire. Ensure correct routing
in the area of the docking station, @ 11.
► Check for correct connection of the perimeter wire
ends in the docking station, @ 10.5.
► Check the routing of the perimeter wire, @ 10.7.
► Contact an authorized STIHL iMow servicing dealer.
► Increase the cutting height, @ 16.4.
► Clean the drive wheels, @ 19.
► Fill up holes in the mowing area, install restricted
areas around obstacles such as exposed roots,
remove obstacles.
► Remove the obstacle or block it off with a restricted
area, @ 11.5.
21 Troubleshooting Guide
0478-131-3045-A