Menu
Sync Mode
H/Comp
Video
RGB/YUV
Auto
RGB
YUV
Color System
RGB Signal
HD15/DVI/HDMI
Screen Saver
Off
All White
Sweep
Standby
Menu Position
Landscape
Portrait
Function and operation
Set the type of signal input at pin 13 of the HD15 (RGB/COMPONENT) IN
connector (page 45).
Notes
• "Sync Mode" is available only when analog RGB signal is input to HD15
connector.
• There are some inputs for which only "H/Comp" can be selected. In this case,
input horizontal/vertical synchronization signals through the pin 13 or 14 of the
connectors.
• This display does not support the three value sync format of 576/60p.
• When "Video" is selected in "Sync Mode", you can only set the 575/50i and 480/
60i signals.
Sets a horizontal synchronous signal input.
Sets a video signal input.
Sets the type of signal for a piece of video equipment or PC connected to the HD15
(RGB/COMPONENT) connector of the display.
Automatically sets whether an analog RGB signal or a component signal is input
from a connected device.
Set when an analog RGB signal is input from a connected device.
Set when a component signal is input from a connected device.
Select "Auto" to set the color system automatically. Select "NTSC" or "PAL" to set
the color system.
Note
"Color System" is available when the input signal is from a VIDEO IN connector
(Composite video signal).
Set whether a 1280 × 720/60, 720 × 480/60 or 1920 × 1080/60 RGB input signal is
displayed as a PC signal or a video signal.
Select "HD15", "DVI" or "HDMI" according to the input connector, and then
select "PC" or "Video" for each. The following input connectors are valid for each
setting "HD15", "DVI" or "HDMI".
"HD15": HD15 (RGB/COMPONENT) IN connector
"DVI": DVI IN connector
"HDMI": HDMI IN connector
This is a setting to prevent or reduce screen burn or after-image that can occur by
long periods of screen display of the same image.
Disables the "Screen Saver" setting.
Displays an all-white screen. (Stops automatically after about 30 minutes and the
display enters standby mode.)
Scrolls a white bar over the screen.
Turns on a screensaver for the time set in "Timer Setting" in standby (page 10).
(The display is blank during screensaver operation.) When the set time has passed,
the display returns to the regular standby state.
Changes the menu screen's orientation to match the display's installation
orientation.
Show the menu screen horizontally.
Show the menu screen vertically.
GB
33
GB