Oil Quantity Control - Stihl MS 460 Manual De Instrucciones

After long period of full-throttle
operation
Allow engine to run for a short while at
idle speed so that engine heat can be
dissipated by flow of cooling air. This
protects engine-mounted components
(ignition, carburetor) from thermal
overload.
After finishing work
:
Slacken off the chain if you have
retensioned it at operating
temperature during cutting work.
The chain contracts as it cools
down. If it is not slackened off, it
could damage the crankshaft and
bearings.
Storing your saw for a short period:
Wait for engine to cool down. To avoid
condensation, fill the fuel tank and keep
the machine in a dry place, well away
from sources of ignition, until you need it
again.
Storing for a long period:
See "Storing the Unit"!
MS 460, MS 460 R
Oil Quantity
Control
1
Different quantities of oil are required for
different bar lengths, types of wood and
cutting techniques.
:
Use the adjusting screw (1) (on
underside of machine) to vary the
oil feed rate as required.
:
E = Ematic position, medium oil flow
rate - turn adjusting screw to "E"
(Ematic position)
:
To increase oil feed – turn adjusting
screw clockwise.
:
To reduce oil feed – turn adjusting
screw counter-clockwise.
Your chain must always be wetted
with a film of lubricant.
English / USA
Oil Pump with Higher Flow Rate
(special option)
Oil pumps with a slot (2) in the
adjusting screw: When the pump is
set to range "a", the oil tank may run
dry before the fuel tank and the
chain will not be lubricated.
:
When using range "a", either fill the
fuel tank to only half its normal
capacity or refill the oil tank when
the fuel tank is still about half full.
39