Stihl MS 460 Manual De Instrucciones página 21

English / USA
Open-face technique
C = felling notch - determines the
direction of the fall
For an open-face cut:
:
Properly place felling notch
perpendicular to the line of fall,
close to the ground.
:
Cut down at approx. 50-degree
angle to a depth of approx.1/5 to
1/4 of the trunk diameter.
:
Make second cut from below at
approx. 40 degree angle.
:
Remove resulting 90-degree piece.
20
Making sapwood cuts
:
For medium sized or larger trees
make cuts at both sides of the trunk,
at same height as subsequent
felling cut.
:
Cut to no more than width of guide
bar.
This is especially important in softwood
in summer - it helps prevent sapwood
splintering when the tree falls.
D
D = Felling cut
Conventional and open-face technique:
:
Begin 1 to 2 inches (2,5 to 5 cm)
higher than center of felling notch.
:
Cut horizontally towards the felling
notch.
:
Leave approx.1/10 of diameter
uncut. This is the hinge.
:
Do not cut through the hinge - you
could lose control of the direction of
the fall.
MS 460, MS 460 R
D