Conditions Of Installation And Normal Operation - FPZ SCL R20-MD GOR ATEX Manual De Instrucciones

R-MD GOR ATEX 2G
9.2

CONDITIONS OF INSTALLATION AND NORMAL OPERATION

Startup and operation must occur only under the following conditions:

The unit must be completely assembled and intact, i.e. not damaged or tampered with.

The silencers/manifolds must be properly connected to the system piping.

The machine must be securely fixed in place.

The motor must be connected to a suitable control panel.

If installed outdoors, protect the unit against the sun and weather.
Risk of injury due to shearing, crushing and catching
During work on the unit there are risks of injury due to shearing, crushing or catching.
Therefore it must be carried out by technicians who handle and install the machine, taking the necessary safety measures and
following the instructions given in this manual.
Danger due to escaping process fluids
Danger due to overpressure with sudden release of process fluids (injury to the skin and eyes)!
Start the machine only if properly connected.
Danger due to electricity
Work on the electrical equipment must only be carried out by qualified and authorised electricians!
Before starting work on the unit or system, take the following precautions:
- disconnect the mains power;
- open the terminal box only after making sure the power is disconnected;
- take steps to prevent the power from being reconnected.
Danger of suction
Danger due to negative pressure: sudden drawing in of hair and clothing. Start the machine only if properly connected.
Danger due to seizing of the impeller caused by performance values being exceeded
Use the blower, making sure that the operating conditions comply with the values given in the "SPECIFICATIONS" and the electric
motor RATING DATA.
Never operate the unit, even temporarily (if not foreseen), with the inlet and/or outlet port closed.
FPZ-MI-R-MD-MOR-GOR-ATEX-15-R00
R-MD GOR ATEX 3GD
33 / 111
R-MD MOR ATEX 3GD