Anatomical Backrest; Adjust The Brakes - Vermeiren Eclips X4 kids 90 Manual De Instrucciones

6. Remove the adjustable axle adapter, if available on your wheelchair.
7. Adjust the seat depth to the desired position by moving the backframe  and/or seat
frame  steps from 20 mm.
8. Tighten all the screws properly by hand.
9. Fold the flap of the backrest under the seat (Velcro fastening), to close the gap between
the back frame and the seat.
10. Adjusting the seat is not necessary.
11. Replace the armrests, footrests and rear wheels. Mount the armrests in the correct hole
of attachment plate .
3.6

Anatomical backrest

L
WARNING:
Risk of injury – Check that the backrest is secure before use.
L
WARNING:
Risk of injury – Avoid getting your fingers caught during the
assembly process.
3.7

Adjust the brakes

L
WARNING:
Risk of injury – Brakes may only be adjusted by your specialist
dealer.
Adjust the brakes according following rules:
To use the anatomical backrest, proceed as follows:
1. Unscrew the flexible backrest.
2. Loosely screw on the brackets for the backrest.
3. Insert the backrest into the brackets from above.
4. Tighten the screws holding the brackets for the
backrest.
5. Insert and tighten the safety screws for the
backrest.
6. Add the armrests.
1. Install the wheels according § 2.2.
2. Disconnect the brakes by pulling lever
backwards.
3. Loosen the bolts
mechanism can slide over the guide
4. Pull the brake mechanism over the guide
the desired position.
5. Retighten the bolts .
6. Check working of the brakes.
7. If necessary repeat the above steps until the
brakes are adjusted well.
Page 16
Eclips X4 kids 90°


so the brake

.
2014-08

to