Panasonic EY7410 Manual De Instrucciones página 9

Li-ion Battery Pack
NOTE:
Your battery pack is not fully charg-
ed at the time of purchase. Be sure
to charge the battery before use.
Ni-MH Battery Pack
NOTE:
When you charge the battery pack
for the first time, or after prolonged
storage, charge it for about 4
hours to bring the battery up to full
capacity.
How to charge
1. Plug the charger into the AC outlet.
NOTE:
Sparks may be produced when the
plug is inserted into the AC power
supply, but this is not a problem in
terms of safety.
. Select the current battery dock (Li-ion
Battery pack or Ni-MH Battery pack)
cover. Slide the battery dock cover to
allow insertion.
3. Insert the battery pack firmly into the
charger.
To AC
outlet
4. During charging, the charging lamp
will be lit.
When charging is completed, an inter-
nal electronic switch will automatically
be triggered to prevent overcharging.
• Charging will not start if the battery
pack is warm (for example, immedi-
ately after heavy-duty operation).
The orange standby lamp will be
flashing until the battery cools down.
Charging will then begin automati-
cally.
Pictured:
Li-ion Battery Pack
5. The charge lamp (green) will flash
slowly once the battery is approxi-
mately 80% charged. (Li-ion Battery
Only)
6. When charging is completed, the
charging lamp in green color will turn
off.
7. If the temperature of the battery pack
is 0°C or less, charging takes longer
to fully charge the battery pack than
the standard charging time.
Even when the battery is fully charg-
ed, it will have approximately 50% of
the power of a fully charged battery at
normal operating temperature.
8. Consult an authorized dealer if the
charging lamp (green) does not turn
off.
9. If a fully charged battery pack is
inserted into the charger again, the
charging lamp lights up. After several
minutes, the charging lamp in green
color will turn off.
- 9 -
EN EN