Weather Forecast; Backlight - Hama EWS-890 Instrucciones De Uso

• Press the ALARM SET button (12) as needed to activate/
deactivate the alarm.
• The alarm symbol (4) will either be displayed or not displayed
accordingly.
• When the alarm is triggered, the alarm symbol (4) begins to flash
and an alarm sounds.
• Press the ALARM SET button (12) to stop the alarm. Otherwise,
it will stop automatically after 2 minutes.
Note – Snooze function
• While the alarm is sounding, press the SNOOZE/LIGHT
button (11) to activate the snooze function. The alarm symbol
(4) begins to flash on the display. The alarm is stopped for 5
minutes, after which it will sound again.
• The snooze function can be used over a 24-hour period.
Celsius/Fahrenheit
• Move the °C/°F slide switch (14) to the °C or °F position to
display the temperature (2,8) in the respective unit.

6.4 Weather forecast

Based on changes in the atmospheric pressure and the data saved,
the base station is able to make weather forecasts for the next 12
to 24 hours.
Note – Weather forecast
• The weather forecast function is not available during the
first few hours of operation because it reuqires data that is
collected during operation.
• The probability of an accurate weather forecast is around
70–75%.
• The weather forecast and the current weather are indicated by
four different symbols (6):
Symbol (6) Weather
Sun
Slightly cloudy
Cloudy
Rain
6.5. Maximum and minimum temperature and humidity
values
• The base station automatically stores the maximum and
minimum indoor/outdoor temperature and humidity values.
• Repeatedly press the MEM– button (17) to switch between the
current temperature and humidity, minimum temperature and
humidity (MIN) and maximum temperature and humidity (MAX).
• The maximum and minimum values are displayed for 5 seconds.
• Press and hold the MEM– button (17) to reset the stored
maximum and minimum values.
6.6. Frost warning
• If the outdoor temperature (8) is between -2°C and ~ 3°C,
the frost warning symbol
continuously.
• The frost warning symbol
rises above this range.

6.7. Backlight

Note – Backlight
• If you press the SNOOZE/LIGHT button (11), the display will
light up for approx. 5 seconds.
6.8. Low battery charge
As soon as the battery symbol
base station, the capacity of the batteries in the measuring station
is very low. Replace the batteries immediately.
Note – Replacing the batteries
• Note that the stations have to be resynchronised each time
after you change the batteries in the measuring or base
station.
• To do this, remove the batteries from the other station and
then reinsert them, or change them as required.
6.9. Reset
• If displays/transmissions continually fail to appear or are
incorrect, use a pointed object (paper clip, etc.) to press the
RESET button (18) on the base station and the RESET button
(24) on the measuring station to carry out a restart.
• The base station returns to the factory settings and all stored
information is lost.
7. Care and Maintenance
Only clean this product with a slightly damp, lint-free cloth and do
not use aggressive cleaning agents. Make sure that water does not
get into the product.
appears on the LCD and flashes
disappears once the temperature
appears on the display of the
5