Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Installing the Rope Rotor
a
a = 2mm
(0.08 in)
:
Check dimension a for inner spring
anchor loop and bend it slightly if
necessary.
:
Coat rope rotor bearing bore with
non-resinous oil – see "Special
Accessories".
8
:
Slide the rotor onto the starter post –
turn it back and forth until the rewind
spring anchor loop (8) engages.
:
Insert the screw (5) and tighten it
down securely.
:
Go to "Tensioning the Rewind
Spring".
FS 75
Tensioning the Rewind Spring
:
Make a loop in the unwound
starter rope and use it to turn
the rope rotor six full revolutions
counterclockwise. Hold the rotor
steady – straighten the twisted rope
– release the rotor –
let go of rope slowly so that it winds
onto the rotor.
:
Check spring tension:
–
The starter grip must be firmly
seated in the rope guide bushing.
If the grip droops to one side: Add
one more turn on rope rotor to
increase spring tension.
–
When the starter rope is fully
extended it must be possible to
rotate the rotor another half turn. If
this is not the case, the spring is
overtensioned and could break.
Take one turn of rope off the rotor.
:
Go to "Fitting the Starter Cover".
English / USA
Fitting the Starter Cover
1
2
1
3
:
Push the upper mounting boss (2)
under the shroud (4) –
line up the tank (3)and push the
lower part of cover onto the tank.
:
Insert and tighten down the housing
screws (1).
4
1
29
Capítulos
Tabla de contenido
