Lift Master Forms; Manufacturer; Purpose; Changes To The Design / Construction - Nussbaum POWER LIFT HL 2.50 NT Instrucciones De Servicio

página de 228

/ 228
Contenido
Tabla de contenido

Tabla de contenido

Idiomas disponibles

Lift master forms

9.1

Manufacturer

Otto Nußbaum GmbH & Co.KG

Korker Straße 24

D-77694 Kehl-Bodersweier

9.2

Purpose

The lift is a lifting tool for raising motor vehicles in normal workshop operation. A total weight of max. 5.000

kg for a maximum load distribution of 3:1 or 1:3 in the drive in direction or against the drive-in direction may

not be exceeded. Single loading of the carrier arm may not occur.

Set up of the standard lift in explosion endangered workshops and humid spaces (e.g. washing halls) is

prohibited. This is only possible with custom equipment.

Lift operation is done directly on the operating column.

After construction and maintenance changes on load carrying parts the lift must be inspected afterwards

by a specialist who approves the changes. If the set up location is changed, the lift must be checked

again by a specialist and changed approved.

Carrier arm variants

POWER LIFT HL 2.50 NT

9.3

Changes to the design / construction

Inspections by a technical expert are required before recommissioning (date, type of change, technical

expert signature).

..................................................................................................................................................................................

Name, address of technical expert

......................................................................................

Location, date

9.4

Changing the assembly location

Inspections by a technical expert are required before recommissioning (date, type of change, specialist

signature).

..................................................................................................................................................................................

Name, address of technical expert

......................................................................................

Location, date

20110002 POWER LIFT HL 2.50 NT - HYMAX HL 5000 PH OPI

Standard arm and

Standard arm

extension 220 mm

778-1213 mm

Max. 1433 mm

Version 1.0

Double swivel arm

(DG)