Tabla de contenido
Idiomas disponibles
Idiomas disponibles
INSTALLATION INSTRUCTIONS
Remove Transport System
Max. packed weight:
PD model: 115 kg (253.53 lb)
PN model: 111 kg (244.71 lb)
Max. unpacked weight:
PD model: 111 kg (244.71 lb)
PN model: 107 kg (235.89 lb)
IMPORTANT: Position the washer so that the rear of the washer
is within approximately 900 mm (3 ft.) of its final location.
There are 4 shipping bolts in the rear panel of the washer that
support the suspension system during transportation. These bolts
also retain the power cord inside the washer until the bolts are
removed.
1. Keep the washer in the upright position while removing the
shipping bolts.
Shipping bolt
Shipping bolt with plastic spacer
2. Using a 13 mm (1/2") wrench, loosen each of the bolts.
3. Once the bolt is loose, move it to the center of the hole
and completely pull out the bolt, including the plastic spacer
covering the bolt.
4. Once all 4 bolts are removed, discard the bolts and spacers.
Then push the plug back into the back of the washer and pull
the power cord through the left opening of the rear panel and
close the hole with the attached cap.
5. Close the bolt holes with the 4 transport bolt hole plugs.
NOTE: If the washer is to be transported at a later date, call your
product distributor or installer. To avoid suspension and structural
damage, your washer must be properly set up for relocation by a
trained professional.
Power Cord Installation
1. Select the plug that fits with the electric receptacle.
2. Assemble the plug into the end of the power cord.
3. Secure the power cord by seating the connection on the cord
lock.
4. Place the cord lock cover and push until it snaps.
5. Make sure the power cord connection is seated on the cord
lock and that the cord lock clamps correctly.
7
Tabla de contenido
