Tabla de contenido
Idiomas disponibles
Idiomas disponibles
While holding the lower guard at the uppermost
position, tighten the cover plate screw with a Phillips
screwdriver.
(6) Lower the lower guard and verify that operation of the
guard does not bind or stick.
(7) Be sure the spindle lock is released so the blade turns
freely.
CAUTION
Never attempt to install saw blades larger than
10" (255 mm) in diameter.
Always install saw blades that are 10" (255 mm)
in diameter or less.
ABOUT REMAINING BATTERY INDICATOR
You can check the battery's remaining capacity by
pressing the remaining battery indicator switch to light the
indicator lamp. (Fig. 51, Table 5)
The indicator will shut off approximately 3 seconds after
the remaining battery indicator switch is pressed.
It is best to use the remaining battery indicator as a
guide since there are slight diff erences such as ambient
temperature and the condition of the battery.
Also, the remaining battery indicator may vary from those
equipped to a tool or charger.
Remaining battery
indicator lamp
Display panel
Remaining battery
indicator switch
Fig. 51
State of lamp
Lights ;
The battery remaining power is
over 75%.
Lights ;
The battery remaining power is
50% – 75%.
Lights ;
The battery remaining power is
25% – 50%.
Lights ;
The battery remaining power is
less than 25%.
Blinks ;
The battery remaining power is nearly
empty. Recharge the battery soonest
possible
Blinks ;
Output suspended due to high
temperature. Remove the battery
from the tool and allow it to fully cool
down.
Blinks ;
Output suspended due to failure or
malfunction. The problem may be the
battery so please contact your dealer.
The Table 5 shows the state of remaining battery indicator
lamp and the battery remaining power.
NOTE
Do not give a strong shock to the display panel or
break it. It may lead to a trouble.
English
Table 5
Battery Remaining Power
37
Tabla de contenido
