About Remaining Battery Indicator - Metabo HPT C 3607DRA Manual De Instrucciones

English
○ Tighten the left hex. 7 mm socket bolt so it does not
come loose during operation.
○ Confi rm the left hex. 7 mm socket bolt has been
properly tightened before the power tool is started.
○ Confi rm that the lower guard has closed position.
2. Dismounting the saw blade
Dismount the saw blade by reversing the mounting
procedures described in paragraph 1 above.
The saw blade can easily be removed after lifting the
lower guard.
Safeguard Function
Overburden Protection
Temperature Protection

ABOUT REMAINING BATTERY INDICATOR

You can check the battery's remaining capacity by
pressing the remaining battery indicator switch to light the
indicator lamp. (Fig. 57, Table 6)
The indicator will shut off approximately 3 seconds after
the remaining battery indicator switch is pressed.
It is best to use the remaining battery indicator as a
guide since there are slight diff erences such as ambient
temperature and the condition of the battery.
Also, the remaining battery indicator may vary from those
equipped to a tool or charger.
Remaining battery
indicator lamp
Display panel
38
LED Light Display
On 0.1 second/off 0.1 second
On 0.5 second/off 0.5 second
Remaining battery
indicator switch
Fig. 57
CAUTION
Never attempt to install saw blades except
180 mm in diameter.
LED LIGHT WARNING SIGNALS
This product features functions that are designed to protect
the tool itself as well as the battery. While the switch is
pulled, if any of the safeguard functions are triggered
during operation, the LED light will blink as described in
Table 5. When any of the safeguard functions are triggered,
immediately remove your fi nger from the switch and follow
the instructions described under corrective action.
Table 5
Remove the cause of the overburdening.
Allow the tool and battery to thoroughly cool.
State of lamp
The Table 6 shows the state of remaining battery indicator
lamp and the battery remaining power.
Corrective Action
Table 6
Battery Remaining Power
Lights ;
The battery remaining power is
over 75%.
Lights ;
The battery remaining power is
50% – 75%.
Lights ;
The battery remaining power is
25% – 50%.
Lights ;
The battery remaining power is
less than 25%.
Blinks ;
The battery remaining power is nearly
empty. Recharge the battery soonest
possible
Blinks ;
Output suspended due to high
temperature. Remove the battery
from the tool and allow it to fully cool
down.
Blinks ;
Output suspended due to failure or
malfunction. The problem may be the
battery so please contact your dealer.