Before Using - Metabo HPT C 3610DRA Manual De Instrucciones

English
○ Charging a USB device and battery from a
electrical outlet (Fig. 13-c)
a
(2) Turn the USB power switch ON (Fig. 14)
When you turn the USB power switch ON, the USB
power indicator lamp will light up.
Rubber cover
USB cable
USB port
(3) Connect the USB cable. (Fig. 14)
Pull back the rubber cover and fi rmly plug in a
commercially available USB cable (appropriate to the
device being charged) into the USB port.
○ When the power cord is not plugged into an outlet and
the battery runs out of power, power output will stop
and the USB power indicator lamp will shut off .
○ When the USB power indicator lamp goes out, change
the battery or plug the power cord into an electrical
outlet.
(4) When charging is completed
○ The USB power indicator lamp will not go out when a
USB device has been completely charged.
To verify charge status, check the USB device.
○ Turn the USB power switch OFF and unplug the power
cord from the electrical outlet. (Fig. 14)
○ Remove the battery from the charger and place the
rubber cover over the USB port.

BEFORE USING

Power tool
WARNING
Check steps 1 through 6 before you have
installed the power supply (battery) to the tool.
20
b
Fig. 13
USB power
switch
USB power
indicator lamp
Fig. 14
1. Make sure the trigger switch is turned OFF.
WARNING
If the battery is inserted while the power switch
is in the ON position, the power tool will start
operating immediately, inviting serious accident.
2. Check the saw blade for visible defects.
Confi rm that the saw blade is free of cracks or other
visible damage.
c
3. Confi rm that the saw blade is attached securely to the
power tool.
Using the supplied 13 mm wrench, tighten the 8 mm
bolt on the saw blade spindle to secure the saw blade.
For details, see Fig. 50-a, Fig. 50-b, Fig. 50-c and
Fig. 50-d in the section on "SAW BLADE MOUNTING
AND DISMOUNTING".
4. Check the lower guard for proper operation.
Lower guard is designed to protect the operator
from coming into contact with the saw blade during
operation of the tool.
Always check that the lower guard moves smoothly
and covers the saw blade properly.
Lower guard
WARNING
NEVER OPERATE THE POWER TOOL if the lower
guard does not function smoothly.
5. Confi rm the position of the spindle lock before using
the tool.
After installing the saw blade, confi rm that the spindle
lock has been returned to the released position before
using the power tool (see Fig. 3).
6. Eye protection
Always wear eye protection with side shields that
meets the requirements of ANSI Standard Z87.1.
Ordinary eyeglasses do not provide adequate
protection because they do not contain impact
resistant safety glass.
Fig. 15