Tabla de contenido
Idiomas disponibles
Idiomas disponibles
4. Installing the dust bag and vise
Install the dust bag onto the dust port on the miter
saw. Fit the connecting tube of dust bag and the dust
port together.
To empty the dust bag, pull out the dust bag assembly
from dust port. Open zipper on underside of bag and
empty into waste container. Check frequently and
empty the dust bag before it gets full.
Dust bag
NOTE
The dust bag should be angled toward the right side
of the saw for best results. This will also avoid any
interference during the saw operation.
CAUTION
Empty the dust bag frequently to prevent the duct
and the lower guard from becoming clogged.
Sawdust will accumulate more quickly than
normal during bevel cutting.
WARNING
Do not use this saw to cut and/or sand metals.
the hot chips or sparks may ignite saw dust from
the bag material.
(Attach the vise assembly as shown in Fig. 2, Fig. 3
and Fig. 31.)
Dust port
Fig. 10
REMOVAL AND INSTRUCTION METHOD
OF BATTERY OR AC/DC ADAPTER
○ How to install the battery or AC/DC adapter.
Align the battery or AC/DC adapter with the groove in
tool handle and slip it into place.
Always insert it all the way until it locks in place with a
little click, If not, it may accidentally fall out of the tool,
causing injury to you or someone around you (Fig. 11).
○ How to remove the battery or AC/DC adapter.
Withdraw battery or AC/DC adapter from the tool
handle while pressing the latch (2 pcs) of the battery
or AC/DC adapter (Fig. 11).
Battery
Pull out
Insert
CHARGING METHOD
NOTE
Before plugging into the receptacle, make sure the
following points.
○ The power source voltage is stated on the
nameplate.
○ The cord is not damaged.
WARNING
Do not charge at voltage higher than indicated
on the nameplate.
If charged at voltage higher than indicated on the
nameplate, the charger will burn out.
1. Connect the charger's power cord to a receptacle.
When the power cord is connected, the charge
indicator lamp will blink in red. (At 1-second intervals)
WARNING
Do not use the electrical cord
if
damaged.
immediately.
English
Latch
Push
Fig. 11
Have
it
repaired
17
Tabla de contenido
