Assembly And Operation; Removal And Installation Method Of Battery; Charging Method - Metabo HPT CR 14DSL Manual De Instrucciones

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

English
APPLICATIONS
○ Cutting metal and stainless steel pipe.
○ Cutting various lumber.
○ Cutting mild steel, aluminum and copper plate.
○ Cutting synthetic resins, such as phenol resin and
vinyl chloride.
REMOVAL AND INSTALLATION METHOD
OF BATTERY
○ How to install the battery.
Align the battery with the groove in tool handle and
slip it into place.
Always insert it all the way until it locks in place with a
little click, If not, it may accidentally fall out of the tool,
causing injury to you or someone around you (Fig. 3).
○ How to remove the battery.
Withdraw battery from the tool handle while pressing
the latch (2 pcs) of the battery (Fig. 3).
Insert
Pull out
Battery

CHARGING METHOD

NOTE
Before plugging into the receptacle, make sure the
following points.
○ The power source voltage is stated on the
nameplate.
○ The cord is not damaged.
WARNING
Do not charge at voltage higher than indicated
on the nameplate.
If charged at voltage higher than indicated on the
nameplate, the charger will burn out.
1. Connect the charger's power cord to a receptacle.
When the power cord is connected, the charger's pilot
lamp will blink in red. (At 1-second intervals)
10

ASSEMBLY AND OPERATION

Handle
Latch
Push
Fig. 3
WARNING
Do not use the electrical cord
if damaged. Have it repaired
immediately.
2. Insert the battery to the battery charger.
Insert the battery into the battery charger as shown in
Fig. 4.
<UC18YRSL>
Pilot lamp
<UC18YFSL>
Pilot lamp
Charger
<UC18YGSL>
Insert the battery into the battery charger as shown in
Fig. 5. Make sure it contacts the bottom of the battery
charger.
BSL1415X
Battery
Charger
Battery
Fig. 4
BSL1815X
Fig. 5
Tabla de contenido
loading

Este manual también es adecuado para:

Cr 18dsl

Tabla de contenido