Idiomas disponibles
Idiomas disponibles
To attach the loop handle
1. Attach the loop handle to the shaft in compliance
with the illustration and tighten.
122L
2. Make sure that the loop handle attaches between
the arrows on the shaft.
To attach the J-handle (only for 122RJ)
WARNING:
when you install the J-handle. Use only
grass blades/grass cutters or trimmer heads/
plastic blades.
1. Attach the J-handle to the loop handle in compliance
with the illustration and tighten.
To install the harness clamp (only for
122RJ)
1. Put the top harness clamp on the shaft. Put the low
harness clamp below the shaft.
2. Align the screws in the top and low harness clamp.
3. Install two screws into the screw holes.
4. Tighten the screws to connect the harness clamp.
To install a blade guard, grass blade
and grass cutter
CAUTION:
guard for the blades. See .
10
122RJ
Do not use saw blades
Only use the approved
1. Attach the blade guard/cutting attachment guard (A)
onto the shaft and tighten with the bolt.
G
F
E
2. Install the drive disc (B) on the output shaft.
3. Turn the output shaft until one of the holes in the
drive disc aligns with the related hole in the gear
housing.
4. Put the hex key (C) in the hole to lock the shaft.
5. Put the blade (D), support cup (E) and support
flange (F) on the output shaft.
6. Install the nut (G). Torque the nut to 35-50 Nm
(26-36 ft/lb). Hold the shaft of the wrench near the
blade guard as much as possible. To tighten the nut,
you must turn the wrench in the opposite direction of
rotation.
Note:
Left hand thread.
To install blades and trimmer heads
WARNING:
guard for the blades. See . A damaged
guard can cause injury.
WARNING:
with a grass blade, first install the correct
handlebar, blade guard and harness .
WARNING:
blades correctly, it can cause injury.
1. Make sure that the lifted section on the drive disc/
support flange engages correctly in the center hole
of the blades.
2. Install the blades.
A
D
Only use the approved
If you operate the product
If you do not install the the
2227 - 002 - 19.07.2024
B
C
