Idiomas disponibles
Idiomas disponibles
Product Safety Information
Intended Use:
These Air Impact Wrenches are designed to remove and install threaded fasteners.
For additional information refer to Product Safety Information Manual Form 04580916.
Manuals can be downloaded from ingersollrandproducts.com.
Product Specifications
Models
Style
631L
Outside Trigger Square 8" extended
631S
Outside Trigger
Models
631L
631S
† K
= 3dB measurement uncertainty
pA
‡ K
= 3dB measurement uncertainty
wA
Sound and vibration values were measured in compliance with internationally recognized
test standards. The exposure to the user in a specific tool application may vary from these
results. Therefore, on site measurements should be used to determine the hazard level in
that specific application.
Installation and Lubrication
Size air supply line to ensure tool's maximum operating pressure (PMAX) at tool inlet. Drain
condensate from valve(s) at low point(s) of piping, air filter and compressor tank daily. Install
a properly sized Safety Air Fuse upstream of hose and use an anti-whip device across any
hose coupling without internal shut-off, to prevent hose whipping if a hose fails or coupling
disconnects. See drawing 47132790 and table on page 2. Maintenance frequency is shown in a
circular arrow and defined as h=hours, d=days, and m=months of actual use. Items identified as:
1. Air filter
2. Regulator
3. Lubricator
4. Emergency shut-off valve
5. Hose diameter
6. Thread size
45496114_ed5
Drive
Type
Size
1"
Square Standard
1"
Sound Level dB(A)
(ISO15744)
† Pressure (L
)
p
108.4
108.4
WARNING
7.
8.
9.
10. Grease - during assembly
11. Grease - through fitting
Recommended Torque Range
Impacts
per Min.
700
200-2500 (271-3390)
700
200-2500 (271-3390)
‡ Power (L
)
Level
w
119.4
119.4
* K = Vibration measurement uncertainty
Coupling
Safety Air Fuse
Oil
EN
Forward
ft-lb (Nm)
Vibration (m/s²)
(ISO28927)
* K
12.7
2.5
12.7
2.5
EN-1
