Idiomas disponibles
Idiomas disponibles
• The symbol of the crossed-out dustbin means that
waste electrical and electronic equipment must not
be disposed of with household waste.
• Waste electrical and electronic equipment can be
handed in free of charge at the following places:
- Public disposal or collection points (e.g. municipal
works yards).
- Points of sale of electrical appliances (stationary
and online), provided that dealers are obliged to
take them back or offer to do so voluntarily.
- Up to three waste electrical devices per type of
device, with an edge length of no more than 25
centimetres, can be returned free of charge to
the manufacturer without prior purchase of a new
device from the manufacturer or taken to another
authorised collection point in your vicinity.
18. Troubleshooting
The following table shows fault symptoms and describes remedial measures in the event of your product failing to
work properly. If you cannot localise and rectify the problem with this, please contact your service workshop.
Fault
Heavy pressure
fluctuations.
Product does not run.
Product has no pressure.
Leaks in the water
system.
28 | GB
Possible cause
Nozzle dirty or clogged.
Product switched off. On/off switch (5)
switched off.
Damaged mains connection cable.
Faulty power supply.
Water supply line pressure drop.
Connections not fitted correctly.
www.scheppach.com
- For additional take-back conditions of the man-
ufacturers and distributors, please contact the
respective customer service.
• In the case of delivery of a new electrical device by
the manufacturer to a private household, the latter
may arrange for the free collection of the old elec-
trical device upon request from the end-user. Get in
contact with the manufacturer's customer service.
• These statements only apply to devices installed
and sold in the countries of the European Union
and which are subject to the European Directive
2012/19/EU. Different provisions may apply to the
disposal of electrical and electronic appliances in
countries outside the European Union.
Remedy
Rinse the nozzle with water. If necessary,
clean the nozzle bore with the nozzle
cleaning needle (26).
Switch the product on with the On/Off
switch (5).
Switch the product off and disconnect from
the mains. Check for mains connection
cable for damage.
If necessary, have the mains connection
cable replaced by an authorised specialist.
Check the electrical system for compliance
with the specifications on the type plate.
Check the water supply.
Switch the product off and disconnect from
the mains. Connect the product to the water
lines again.
