36 www.aeg.com
4.1 Ignition of the burner
WARNING!
Be very careful when you use
open fire in kitchen environment.
Manufacturer decline any re-
sponsibility in case of misuse of
the flame
Always light the burner before
you put cookware.
Lightning the burner:
1.
Push the control knob down and
turn it counterclockwise to the maxi-
mum position (
2.
Push the control knob and hold it for
equal or less than 5 seconds. This
lets the thermocouple to warm up. If
not, the gas supply will be interrup-
ted.
3.
Adjust the flame after it is regular.
If the burner does not light after
some tries, check if the crown
and its cap are in correct posi-
tions.
A)
Burner cap
5. HELPFUL HINTS AND TIPS
WARNING!
Refer to the Safety chapters.
5.1 Energy savings
• If possible, always put the lids on the
pans.
).
A
B
C
D
B)
Burner crown
C)
Ignition candle
D)
Thermocouple
WARNING!
Do not keep the control knob
pushed for more than 15 sec-
onds.
If the burner does not light after
15 seconds, release the control
knob, turn it into off position and
try to light the burner again after
minimum 1 minute.
In the absence of electricity you
can ignite the burner without
electrical device; in this case ap-
proach the burner with a flame,
push the relevant knob down
and turn it counter-clockwise to
maximum gas release position.
If the burner accidentally goes
out, turn the control knob to the
off position and try to light the
burner again after minimum 1 mi-
nute.
The spark generator can start au-
tomatically when you switch on
the mains, after installation or a
power cut. It is normal.
4.2 Turning the burner off
To put the flame out, turn the knob to
the symbol
.
WARNING!
Always turn the flame down or
switch it off before you remove
the pans from the burner.
• When the liquid starts to boil, turn
down the flame to barely simmer the
liquid.
WARNING!
Use cookware with diameters ap-
plicable to the size of burners.