JBM 53423 Manual Del Usuario página 6

6. Fit one end of the return spring to the
end of the cotter pin and the other end
to the 10mm bolt which is at the base
of the ram:
4. BEFORE FIRST USE
Before using the lift, purge the hydraulic circuit.
To eliminate any air in the system, fully press the
release valve pedal (1) while pumping the lift pedal
(2) 15 to 20 times.
Test the lift by raising it to its full height and then
lowering it.
5. OPERATING INSTRUCTIONS
Position the lift under the bike, so that the center of
gravity of the bike is over the saddle.
Press the lift pedal to raise the saddle up to the un-
derside of the bike.
Use ratchet tie downs to secure the vehicle to the
anchors.
7. Screw lift pedal with this bolt:
8. Insert the handle and attach it with
the bolt:
· 6 ·