Idiomas disponibles
Idiomas disponibles
CENTRAL BRUSH REPLACEMENT
The good condition of the central brush will ensure a cleaner floor, thereby reducing costs and increasing
environmental sustainability. To replace the central brush, proceed as follows:
1.
Open the left inspection door (1) (Fig.1).
2.
Loosen the knobs (2) of the central brush inspection carter (Fig.2).
3.
Loosen the knob (3) of the central brush lifting arm (Fig.3).
1
1
4.
Remove the central brush inspection carter (4) (Fig.4).
5.
Take the brush out of the tunnel in the machine frame (Fig.5).
6.
Replace the worn brush with a new one.
N.B.: when the brush is mounted correctly, the cusps on the brush form an arrow ˄ when seen from above in
the forward movement direction (Fig.6).
4
4
Rotate the brush until the fastening hooks (5) in the driving towing hook (6) (Fig. 7) correctly enter the slots (7)
7.
in the brush (Fig.8).
8.
Insert the central brush inspection carter (4) (Fig.9).
5
6
7
ATTENTION: make sure the fastening hooks (8) in the idle towing hook (9) (Fig. 10) correctly enter the slots
(10) in the brush (Fig.11).
2
2
5
7
8
73
73
3
3
6
4
9
