Idiomas disponibles
Idiomas disponibles
EMERGENCY BUTTON
The machine is equipped with an emergency button. If any problems are encountered during the work activities, do
the following:
1.
Press the emergency button (1) on the control panel (Fig.1).
CAUTION: this command interrupts the electrical circuit that goes from the batteries to the machine system.
2.
Once the machine has stopped, turn the main switch to its "0" position by turning the key (2) a quarter turn
anti-clockwise (Fig.2).
1
1
3.
Deactivate the emergency button (1) by pulling it.
4.
Eliminate the anomaly that caused the problem.
N.B.: If the anomaly persists, contact a technician at the HILLYARD service centre.
5.
Carry out all the procedures for turning on the machine.
BRAKING CONTROL
The function board in the machine manages a gradual deceleration when the accelerator pedal (1) is released
(Fig.1). In addition, the machine is fitted with a mechanical brake commanded by the pedal (2) (Fig.2).
1
N.B.: if the accelerator pedal (1) is released while moving, the machine electronics start to slow down with a
gentle deceleration ramp that will stop the machine in a parameterised "DECELERATION RAMP STOP"
time. The electric brake is automatically engaged only when the machine stops completely.
N.B.: to change the machine stop time, modify the "DECELERATION RAMP STOP" parameter. See
"DECELERATION RAMP STOP MENU (TRACTION SPEED SETTINGS)" on page 36
INTERFACE CONFIGURATION MANUAL" consigned with the machine documentation.
N.B.: the machine is fitted with a mechanical pedal brake (2) in addition to the machine electronics that
handle the braking process. The mechanical braking action depends on the degree of force applied to the
pedal (2).
2
2
2
1
2
54
54
of the "OPERATOR
