Idiomas disponibles
Idiomas disponibles
N.B.: by selecting the ECO MODE working program on the control display (Fig. 6), the relative symbol (10)
will appear at the bottom of the screen.
N.B.: by selecting the ECO MODE working program, the predefined performance levels (according to those
selected in the function board parameter list) are automatically loaded. To change the working program
parameters, contact your HILLYARD service centre of reference or the one closest to you.
6
7
8.
Press the drive pedal (12) (Fig.7) to begin moving the machine.
12
7
N.B.: as soon as the drive pedal is pressed, the central brush and side brushes are automatically moved to
their working position.
N.B.: the central brush motor is only started up when the central brush is in the working position.
N.B.: the suction motor is only started up when the central brush is in the working position.
N.B.: if the machine is stopped and the drive pedal (12) released while working, the central brush will
automatically move to the intermediate position (raised off the floor) after the DELAY RESET (BRUSHES
BRUSH MOT) time. To change this parameter, contact a HILLYARD service centre or refer to
RESET MENU (BRUSHES BRUSHMOTOR)" on page 27
MANUAL" consigned with the machine documentation.
N.B.: if the machine is stopped and the drive pedal (12) released while working, the side brushes will
automatically move to the position where they are raised off the floor after the DELAY RESET (OPTIONAL
OPT. BRUSH) time. To change this parameter, contact a HILLYARD service centre or refer to
RESET MENU (OPTIONAL BRUSH FUNCTION)" on page 32
CONFIGURATION MANUAL" consigned with the machine documentation.
9.
The machine will now work at full efficiency levels until the end of the job, or until the battery box needs
4
15
8
13
9
16
8
in the "OPERATOR INTERFACE CONFIGURATION
46
46
in the "OPERATOR INTERFACE
6
14
10
"DELAY
"DELAY
