Idiomas disponibles
Idiomas disponibles
ADJUSTING THE DRIVING POSITION
The proper adjustment of the driving position provides a greater sense of comfort when using the machine.
CORRECT POSITION ON THE SEAT: make sure you sit upright and that your back and that your lower back and
spine are at 90°.
LONGITUDINAL SEAT ADJUSTMENT: The seat should always be positioned using the pedals as a reference. To
adjust the seat, use the lever located under it.
N.B.: the distance should be adjusted so that the knees are slightly bent (about 120°) when the pedals are
fully pressed to the floor.
N.B.: adjust the distance of the seat so that the brake pedal reaches the end of its stroke when pressed.
N.B.: your feet should be positioned keeping your heels on the footboard; the pedals should be pressed
using the part of the foot directly behind your toes.
N.B.: the ideal position is that which allows you to grip the steering wheel correctly with the palms of your
hands slightly below shoulder level. With a good grip on the steering wheel, the elbows should be bent by
about 120°. They should be at least 30 cm between the middle of the steering wheel and our breastbone. In
any case, this distance should be no more than 45 cm.
ADJUSTING THE ARMRESTS (OPTIONAL): the armrests should be inclined to make using the machine
comfortable.
N.B.: to adjust the armrest, use the runner located under it.
N.B.: taking the right armrest as a reference, if the wheel is turned outwards the inclination of the armrest is
increased. Taking the left armrest as a reference, if the wheel is turned inwards the inclination of the armrest
is increased.
WEARING THE SAFETY BELT (OPTIONAL) CORRECTLY: the machine comes equipped with a sub-abdominal
safety device, which allows the operator to remain anchored to the driver's seat. To secure the safety belt, you must
first be sitting in the driver's seat; take the mobile part of the belt, wrap it round the abdomen and insert the mobile
part in the slit in the fixed part.
N.B.: adjust the horizontal part of the belt so it is as tight as possible around the pelvis. The belt should be
pulled and put as low as possible on the pelvis bone, and not on the belly.
ASSEMBLING THE CENTRAL BRUSH
To mount the brush in the central tunnel, proceed as follows:
1.
Take the machine to the maintenance area.
2.
Do everything necessary to ensure the machine is in a safe condition. See
CAUTION: it is recommended to wear the appropriate PPE (Personal Protective Equipment), suitable for the
work to be carried out.
3.
Open the left inspection door (1) (Fig.1).
4.
Loosen the knobs (2) of the central brush inspection carter (Fig.2).
5.
Loosen the knob (3) of the central brush lifting arm (Fig.3).
"DASHBOARD" on page
35
35
25.
