Idiomas disponibles
Idiomas disponibles
HOW TO MOVE THE MACHINE
The procedure for transporting the machine full safely is as follows:
CAUTION: it is recommended to wear the appropriate PPE (Personal Protective Equipment), suitable for the
work to be carried out.
1.
Make sure the debris hopper is empty (if necessary, empty it). See
on page
49.
2.
Sit on the driver's seat.
3.
Insert the key (1) in the main machine switch on the right side of the steering column (Fig.1).
4.
Bring the main switch to position "I" by making a quarter turn clockwise with the key (1) (Fig.2).
N.B.: at switch-on, the control display visualises a series of pages, the last of which shows the machine
programming characteristics. See
5.
Make sure the central brush is in the idle position; if this is not the case, press the button (2) on the control
panel (Fig.3).
N.B.: when the central brush is in the idle position, the LED (3) on the button (2) is OFF.
1
1
6.
Make sure the side brush is in the idle position; if this is not the case, press the button (4) on the control panel
(Fig.4).
N.B.: when the side brush is in the idle position, the LED (5) on the button (4) is OFF.
7.
Press the drive pedal (6) (Fig.5) to begin moving the machine.
8.
Use a ramp to move the machine up onto the transport vehicle.
WARNING: bear in mind the ramp must have a suitable slope to avoid damaging the machine, and a
sufficient load-bearing capacity to ensure it does not break when the machine moves across it.
CAUTION: during this operation, check there are no people or objects near the machine.
9.
Place the machine on the transport vehicle.
10. Bring the main machine switch to "0" by making a quarter turn anti-clockwise with the key (1).
11. Remove the key from the main switch.
12. Get off the machine.
13. Grip the handle (7) and turn the upper body (8) to its maintenance position (Fig.6).
"STARTING WORK" on page
1
2
31
31
"EMPTYING THE DEBRIS HOPPER"
45.
3
2
3
