Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Installation Guide continued
□ Installation Location
Do not install this unit on the rear tray of a car where the internal temperature can rise to high levels. Failure to
comply with these instructions may cause problems. Also avoid installing the unit in the following locations.
• In areas hit by direct sunlight, hot air from the heater, or any other high-temperature location.
• In an area where you cannot firmly secure the unit, or in high-vibration areas.
® In areas with high humidity or high dirt and dust levels.
How to Install this unit
Use a screwdriver to set the angle-adjusting hole to the position V or "H," depending on the mounting angle
selected. (When shipped from the factory, the angle-adjusting hole is set to the "H" position as default.)
® When setting vertically: Set to the 'V" position,
o When setting horizontally: Set to the "H" position.
This unit can be set in the five direc¬
tions: horizontai, verticai, and the posi¬
tions A (22.5°), B (45°), and C (67. 5°).
Mount the unit by referring to the fig¬
ures beiow.
Caution
•
Set the angle-adjusting hole to the same angle as
selected.
• Set the holes correctly of the left and right sides
without fail.
^ -V
Angle-adjusting hole
How to install the unit and select the mounting angle
Installation
Angle
Selecting a mounting angle
CO
c
o
N
'C
o
Typical horizontal installation
(Normal)
(Up-side down)
O
X
Limit to less than 10 degrees.
_
ram
o
(D
- - —
u
.}
\
®-v
Limit to less than 10 degrees.
Set the hole to the same positions lor
both left and right.
CO
o
r
5
Typical vertical installation
(Normal)
(Up-side down)
O
X
Do not tilt in this
Limit to
direction. Limit
less than
to less than 10
to de¬
degrees.
grees.
V-
Set the hole to the same positions for
both left and right.
Tabla de contenido
