Idiomas disponibles
Idiomas disponibles
Cancelling a Cycle
Follow the steps below if you would like to
cancel a cycle while in operation.
Open the door of your machine. The selected
cycle will appear on the display. Press and hold
the Start/Pause button(11) for 3 seconds. "0:01"
will be shown on the display. Press Start/Pause
button(11) and after closing the door of the
machine within 4 seconds, the water discharge
process will start and continue for 30 seconds.
When the cycle is cancelled, chime will sound 5
times.
Switching the Machine Off
"0" will be shown on the display when the
selected cycle is complete. Chime will also sound
5 times. You can then switch your machine off
using the Power On/Off button.
NOTE: Do not open the door before the cycle is
complete.
NOTE: If the door of the machine is opened or
the power is cut off while a cycle is in operation,
the cycle will continue when the door is closed or
the power returns.
NOTE: If the power is cut off during
the drying process, the cycle will terminate. Your
machine will be ready for a new cycle selection.
Menu Settings
Press and hold the Extra Dry button(6) for three
seconds to access the menu. Press the Delay
Hours buttons(4) to view available settings in the
menu. Press the Half Load button(5) to select
the desired setting. At this time, the display(3)
blinks, which indicates the setting can be
adjusted by pressing the Delay Hours buttons(4).
Set the new level with the Delay Hours buttons(4)
and press the Half Load button(5) to save the
new level. Once completed, the display will no
longer blink, which indicates the setting level was
saved. Additional settings can be adjusted or
the menu can be exited by pressing the Extra
Dry button(6) for three seconds or by powering
off the dishwasher.
No
Setting
1
Rinse Aid
2
Chime Level
3
Start Cycle
Save Power
4
Mode
Factory
5
Setting
*Default setting
USA - CAN - 27
Options
Description
r:1
r:2
Set the amount of
r:3
rinse aid.
r:4*
r:5
b:0
Set the chime
b:1
level. No chime
will sound at the
b:2
b:0 level
b:3*
LP0*
Set a default cycle
for when the app-
liance switched on.
LP1
SP0
Set the Save
SP1*
Power Mode.
SP2
FS0*
Restore changed
settings to the
FS1
factory settings.
