Idiomas disponibles
Idiomas disponibles
EMERGENCY STOP
EMERGENCY STOP KEY
Before beginning a workout session ensure that the EMERGENCY STOP KEY is placed onto
the Computer Console and the Safety Clip is securely attached to an article of your clothing.
If you fall the clip will pull out the EMERGENCY STOP KEY from the Computer Console and
the running belt will stop immediately for emergency stop, helping to prevent injury.
BELT ADJUSTMENT
The running belt is pre-adjusted to the running deck at the factory, but after prolonged use
it can stretch and require readjustment. To adjust the belt, turn on the main power switch
of the treadmill and let the belt run at a speed of 8-10 KPH. Use the Allen Wrench provided
to turn the rear roller adjustment bolts in order to centre the belt. If the running belt is
shifting to the left, turn the left adjustment bolt 1/4 turn clockwise, and the running belt
should start to correct itself.
If the running belt is shifting to the right, then turn the right adjustment bolt 1/4 turn
clockwise, and the belt should start to correct itself. Keep turning the adjustment bolts until
the running belt is properly centered.
If the running belt is slipping during use, turn off and unplug the treadmill. Using the Allen
Wrench provided, turn both left and right rear roller adjustment bolts 1/4 turn clockwise,
then turn the main power switch back on and run the treadmill at a speed of 8-10 KPH. Run
on to the running belt to determine if the belt is still slipping. Repeat this procedure until
the belt no longer slips.
18
Tool:
Allen Wrench
Tool:
Allen Wrench
Tool:
Allen Wrench
