Idiomas disponibles
Idiomas disponibles
Cleaning the screen element
Removing/fitting a screen element
How to proceed:
Removing
1. Turn the filter drum manually until the screen element is located opposite the drum motor. Undo
the locking mechanism (turn by 180°).
2. Lower the screen element completely into the filter drum.
3. Remove the screen element from the filter drum.
Fitting
4. Lower the screen element completely into the filter drum.
5. Turn the screen element and push the two hinges onto the support of the filter drum.
6. Pull up the screen element on the center bar.
7. Close the locking mechanism (turn by 180°).
Descaling the screen elements
The error messages Er33, Er55 or an excessive increase in the frequency of cleaning cycles (counter)
indicate that there are limescale deposits on the screen elements. (→ Reading out the number of
cleaning cycles)
Oase recommends that you descale the unit every two to three months as a preventative measure if
the water is very hard.
Recommended process for descaling:
• Place screen elements in vinegar concentrate (20 ... 25 % acid) and let them soak for at least 30
minutes until all limescale has been removed.
or
• Sprinkle moistened screen elements with citric acid powder, allow it to act for at least 30 minutes
until all limescale has been removed.
• Recommended cleaning agent for removing stubborn limescale deposits:
– Pump cleaning agent PumpClean from OASE.
– Vinegar- and chlorine-free household cleaning agent.
How to proceed:
1. Remove screen element. (→ Removing/fitting a screen element)
2. Descale screen element.
– Do not remove the rubber seal of the screen element.
3. Scrub the screen element with a soft brush under running water and rinse well.
4. Reinstall the screen element.
44
ProfiClear0041
