Idiomas disponibles
Idiomas disponibles
Er33
20 cleaning cycles in succession
Possible cause
Level detection device stuck or defective
Screen elements heavily soiled
Rinsing pump not operating
Rinsing nozzle clogged
Filter drum not rotating
Level detection device set too low
Water level in the system too high:
•
Outlet pipes soiled
•
Outlet opening too small
•
Excessive flow rate (pump capacity too high)
•
The pond water is very dirty and the filter pump is
conveying an excessive amount of dirt
•
A large amount of dirt has entered the filter sys-
tem, water is flowing over (instead of through) the
foam filters.
Functions that are still available:
•
Manual cleaning
•
Time-dependent cleaning
Resetting message
•
Press
Er44
Motor blocked (the control system has attempted to start up the motor three times with five attempts each)
Possible cause
Filter drum rotating sluggishly or jammed
The lips of the drum seal were squeezed when the
drum was installed.
The drum load is distributed unevenly
Functions that are still available:
•
None
Resetting message
•
Press
38
key for 5 s
key for 5 s
Remedy
Clean the level detection device to ensure that the
mechanism moves freely, replace if necessary.
Clean, descale screen elements (→ Fehler! Verweis-
quelle konnte nicht gefunden werden.)
Clean the bottom of the container, clean the rinsing
pump (→ Fehler! Verweisquelle konnte nicht gefun-
den werden.), check the pump connection
Clean the rinsing nozzle
Check motor connection and/or the rotation move-
ment of the filter drum.
Tip: Mark the filter drum and check on the basis of the
markings if the drum is rotating.
Adjust the level detection device
Clean outlet pipes
Enlarge outlet opening
Reduce flow rate (adjust pump capacity)
Thoroughly clean the pond; if necessary, set up the
pump at an elevated level
Clean foam filters
Remedy
Clean edge of the drum/drum seal and grease edge of
the drum Only use original OASE grease (order num-
ber 27872).
Ensure that the rollers move smoothly
Remove larger particles (e.g. snails, stones) from the
sprocket
Disassemble the drum and ensure that the drum seal
is positioned correctly during re-assembly
Align the container horizontally
