Idiomas disponibles
Idiomas disponibles
MAINTENANCE
Routine cleaning of the equipment
BEFORE CARRYING OUT ANY ROUTINE OR EXTRAOR
DINARY MAINTENANCE WORK, THE EQUIPMENT
MUST BE SWITCHED OFF FROM THE ELECTRICAL
POWER SUPPLY AND APPROPRIATE PERSONAL PRO
TECTIVE EQUIPMENT E.G. GLOVES, ETC. MUST BE
WORN.
THE USER MUST CARRY OUT ONLY ROUTINE MAIN
TENANCE OPERATIONS UNDERSTOOD AS CLEAN
ING . IN CASE OF EXTRAORDINARY MAINTENANCE,
ENTER IN CONTACT WITH AN ASSISTANCE CENTRE
AND REQUEST THE INTERVENTION OF AN AUTHOR
ISED TECHNICIAN.
THE WARRANTY WILL BE VOIDED IN CASE OF DAM
AGES BY THE LACK OF OR INCORRECT MAINTE
NANCE EX. USE OF UNSUITABLE DETERGENTS .
PAY ATTENTION TO HOT PARTS WHEN CARRYING
OUT MAINTENANCE AND CLEANING ON THE MO
TOR
PAY ATTENTION TO SHARP EDGES ON THE SLOTTED
CONVEYORS, ON THE CONDENSING BATTERY THE
FINS ARE PROTECTED BY A FILTER , ON THE MOTOR
SUPPORT BASE DRILLING AND ON THE DASH
BOARD SLOTS.
To clean any component or accessory DO NOT use:
- abrasive or powder detergents;
- aggressive or corrosive detergents (e.g. hydrochloric/muriatic
or sulfuric acid, caustic soda, etc...). Attention! Do not use these
substances, even to clean the pavement under the equipment;
- abrasive or sharp utensils (ex. abrasive sponges, scrapers, steel
brushes, etc...);
- vapour or pressurised water jets.
On the first use wash the pans and the chamber with a cloth
damped with hot water and soap and end with rinsing and dry-
ing. To eliminate work residues, make the equipment work empty
for around 30 minutes.
Cleaning of external steel surfaces
Use a cloth damp with warm soapy water or special products for
steel. Finish with rinsing and drying.
Cleaning of the equipment chamber
Clean the equipment chamber daily to ensure optimum hygiene
levels and machine performance.
For this cleaning, use a cloth damp with water and soap, ending
with rinsing and drying.
Clean slots and grate with a sponge
Keep the slots free of obstructions and dust by cleaning them fre-
quently with an ordinary vacuum cleaner or brush. Periodically, it
is recommended to lift the front panel by removing the screws
below and proceeding to vacuum the dust accumulated on the
condenser fan. Lifting the panel also gives access to the conden-
sate water collection chamber located between the condenser
Rev. 01 - 10/2023
PPE (Personal protective equipment) to be worn during routine
maintenance of the equipment.
H
32
O
2
