General Safety Rules - Festool PF 1200 E Manual De Instrucciones

Aluminium composite milling machine
Technical data
Power
Speed (no load)
Milling tool
- outside diameter
- drill hole diameter
- width
Weight (excluding cable)
Degree of protection
The specifi ed illustrations can be found at the
beginning of the operating instructions.
Graphical symbols
Caution. Danger!
Read the operating instructions/notes
Wear ear protection!
Wear protective goggles!
Wear a protective mask!
1 Intended use
The PF 1200 E is used to route grooves into
composite plates made from aluminium, plastic
(Alucubond®, Dibond®). Only use machine with
attached dust extractor. Only insert milling tools
with the correct dimensions.
The user is liable for damage and injury
resulting from incorrect usage! Do not
use sanding discs.
2 Safety instructions
2.1

General Safety Rules

WARNING!
ings and all instructions. Failure to follow
the warnings and instructions may result
in electric shock, fi re and/or serious in-
jury.
Save all warnings and instructions for future
reference.
The term „power tool" in the warnings refers
to your mains-operated (corded) power tool or
battery-operated (cordless) power tool.
PF 1200 E
1200 W
2000 - 5700 rpm
118 mm
20 mm
14 mm
5.4 kg
/ II
Read all safety warn-
2.2 Tool-specifi c safety rules
Cutting procedures
DANGER!
a) Keep hands away from cutting
area and the milling tool. Keep your second
hand on auxiliary handle, or motor housing.
If both hands are holding the milling machine,
they cannot be cut by the tool.
b) Do not reach underneath the workpiece. The
guard cannot protect you from the tool below
the workpiece.
c) Adjust the cutting depth to the thickness of
the workpiece. Less than a full tooth of the tool
should be visible below the workpiece.
d) Never hold piece being cut in your hands or
across your leg. Secure the workpiece to a
stable platform. It is important to support the
work properly to minimize body exposure, bind-
ing, or loss of control.
e) Hold the power tool by insulated gripping
surfaces only, when performing an operation
where the cutting tool may contact hidden
wiring or its own cord. Contact with a „live"
wire will also make exposed metal parts of the
power tool „live" and could give the operator an
electric shock.
f) When milling, always use a straight edge
guide. This improves the accuracy of cut and
reduces the chance of binding.
g) Always use mounting tools with correct size
and shape (diamond versus round) of arbour
holes. Tools that do not match the mounting
hardware of the milling machine will run ec-
centrically, causing loss of control.
h) Never use mounting tools with damaged or
incorrect washers or bolts. The washers and
bolt were specially designed for your milling
machine, for optimum performance and safety
of operation.
i) Wear suitable protective equip-
ment such as ear protection,
safety goggles, a dust mask for
work which generates dust, and
protective gloves when working
with raw materials and when
changing tools.
Kickback causes and related warnings
– kickback is a sudden reaction to a pinched,
bound or misaligned mounting tool, causing an
uncontrolled machine to lift up and out of the
workpiece toward the operator;
10