Medion X20 SW+ Manual De Instrucciones página 144

6.2. Charging the batt ery
pack
The robot vacuum and mop is fitted with a
lithium-ion battery pack. After unpacking
the appliance, first charge the battery pack
for approx. 6 hours. This benefits battery
performance in the long run.
 Place the robot vacuum and mop on the
charging station so that the charging
contacts are on top of each other.
Operat-
ing light
Lights • Cleaning process active/
up white paused
constantly
• Charging completed
Pulses • Charging process active
white
• Robot is in start mode
Flashes • Charge level low < 20%
red
• General error message
cf."13. Troubleshooting"
on page 154
Off Charging process completed
The robot vacuum and mop automatically
returns to the charging station when the
battery is low.
You can use the button or the app to
instruct the robot vacuum and mop to
automatically return to the charging station
and charge.
This return to the charging station interrupts
the cleaning process.
146
State
If the battery performance decreases
significantly even when charged, contact the
service centre, contact our Service Centre.
7. Vacuum cleaning
mode
NOTICE!
Risk of damage to property!
Loose cabling can get caught around your
robot vacuum and mop during vacuum
cleaning and be pulled along by the device.
This can result in appliances being pulled off
a table and consequently damaged.
 Lay cables out of the reach of the
appliance.
 Remove all fragile items (e.g. glass, lamps,
vases) and objects that could become
trapped in the brushes or sucked up (e.g.
cords, clothing, newspapers, curtains)
from the working area before operating
the device.
This robot vacuum and mop is not suitable
for use on deep-pile carpets.
 Make sure that the dust container is clean
and empty and that the filter is inserted
correctly.
 Press the
button on the appliance for
approx. 5 seconds to switch on the robot
vacuum and mop.
 Press the
button on the appliance
again to start the cleaning process.
 Press the
button again to pause the
cleaning process.
 Press the
button again to continue
cleaning.