Shop-Vac BLB Serie Manual Del Usuario página 9

BLOWER SET UP AND OPERATION (CONT'D.)
2. Insert 2½" extension wand into the blower exhaust. Push firmly into
place by twisting wand slightly. Attach desired accessory.
3. Plug the cord into an electrical outlet. Your portable blower is ready for
use. NOTE: If an extension cord is used, use only an approved outdoor
extension cord. To prevent extension cord from pulling away from
appliance cord, tie cords as shown.
4. To clean inlet shield and foam pad, disconnect cord from receptacle
and remove screws on bottom side of power unit.
5. Once removed, run foam pad under running water and blot with a clean towel to dry.
6. After cleaning, replace inlet shield and foam pad and secure with screws. NOTE: Inlet
shield will only fit properly one way.
GUTTER CLEANING
1. Your portable blower can easily remove leaves and debris from rain gutters using a 120˚ elbow (not
standard with all models), two 2½"extension wands (not standard with all models) and a concen-
trator nozzle (not standard with all models).
2. Remove portable blower from tank cover by grasping both blower handles and pulling
in an upward motion.
3. Connect the 2½" extension wands together. Twist slightly to tighten the connection.
Insert the extension wands into blower exhaust. Twist slightly to tighten the
connection.
4. Attach 120˚ elbow to the extension wands with curve of elbow facing away from you.
Twist slightly to tighten the connection.
5. Attach concentrator nozzle to elbow. Twist slightly to tighten the connection.
6. Plug the cord into an electrical outlet, hold the portable blower with both hands and
turn the unit on.
Extension
Cord
120º
Elbow
Concentrator
Nozzle
Appliance
Cord
Blower
Exhaust
2 1 / "
2
Extension
Wand
PAGE 9