Idiomas disponibles
Idiomas disponibles
INSTALLING AUXILLIARY BATTERY HOLDER KIT - Continued
!
USE ONLY SEALED TYPE BATTERIES!
Failure to comply creates a high risk of ex-
plosion from hydrogen gas. Explosion can
result in death, serious injury and damaged
equipment.
NOTE: Battery is not supplied by Maxon.
Use only sealed type 12V automo-
tive batteries.
8. Install auxiliary battery in battery box
using tie down angle, threaded rods, and
1/4" hex nuts (Kit items)(FIG. 24-1).
9. Connect jumper to battery terminal on
circuit breaker using the 1/4" jumper
hole and attached nut and lock washer
(Kit items) (FIG. 24-2). Tighten circuit
breaker nut to 50 in.-lb. Place circuit
breaker and 5/16" jumper hole over
positive (+) battery terminal (FIG. 24-2).
LIFT CORPORATION Sht. 24 of 76 DSG#
WARNING
M-24-01
TIE DOWN
ANGLE
THREADED RODS
(2 PLACES)
AUXILIARY 12V
BATTERY
INSTALLING 12V AUXILIARY BATTERY
1/4" HOLE
12V AUXILIARY
BATTERY
CONNECT CIRCUIT BREAKER AND JUMPER
Rev. - Date: 05/07/24
HEX NUT, 1/4"
(4 PLACES)
FIG. 24-1
(REF)
CIRCUIT
BREAKER
FIG. 24-2
NUT
LOCK
WASHER
JUMPER
