Idiomas disponibles
Idiomas disponibles
Safety / Preparation / Assembly
- Ejection of portions of the material
being cut
- Hearing damage if the required
hearing protection is not worn.
- Inhalation of exhaust fumes
- Health damage resulting from vi-
bration emissions if the appliance is
used for a prolonged period of time
or is not properly operated and
maintained.
RISK OF DEATH DUE TO
WARNING!
ELECTROMAGNETIC FIELD.
Under certain conditions, the electro-
magnetic field that develops during
operation can adversely affect active
or passive medical implants.
Consult your doctor or the man-
ufacturer of the medical implants
before operating the appliance.
Preparation
Note: Remove all packaging material from the
product. Remove all protective films before using
the appliance for the first time.
Assembly
Installing the depth stop (Fig. C)
Install the depth stop to reinforce the machine's
stability
.
26
Pull the depth stop
26
in the frame as far as the lower borehole.
Insert the bolt
in the hole and fasten it with
31
the nut.
36 GB/IE/NI/CY/MT
from below into the hole
Installing the handlebars (Fig.
D)
Push both handlebars (
2
handlebar bridge
. As you do this, make
9
sure the two cables cross and pass above the
handlebars.
Screw the handlebar bridge
handlebar mount 10. To do this, use a large
diameter washer M8 30 and a screw M8x30
29.
Hold both handlebars (
handlebar mount
and insert the screws
10
with two spring washers and the flat washers.
As you do this, pay attention to the position of
the boreholes. Next, secure the connection by
fastening a locking nut to each of these M8
.
Finally, tighten the screws
Installing the blade guard (Fig.
E)
Slide the blade guard
17
blade shaft and make sure that the positions of
the boreholes correspond.
Push the safety retaining pin
holes in the blade shaft and close the snap
lock.
Repeat the process on the opposite side.
Installing the blade extension
(Fig. F)
Insert the blade extension
bled blade
so that the edge of the blade is
15
pointing in the direction of rotation of the tiller
head.
Pay attention to the proper rotational direc-
tion as you install the blade. The blades are
not symmetrical and therefore cannot be
exchanged, i.e. the right-hand blade cannot
be exchanged for the left-hand blade and
vice versa. The blades must be installed in the
correct rotational direction.
and
) through the
8
onto the
9
and
) against the
2
8
29
32
on both sides.
29
into the pre-installed
through the
34
in the assem-
16
