Idiomas disponibles
Idiomas disponibles
Belt clip
(Fig . J)
m
CAUTION! Risk of injury!
u
Before hanging the product in the belt:
Push the rotation direction switch
the centre position (lock) . This prevents
the product from being switched on
accidentally .
NOTE
u
[
9 ]
The belt clip
allows the tool to be
hooked on belt or pocket .
u
The belt clip is not assembled upon
delivery .
u
The belt clip can be mounted on either side
of a belt .
u
For the assembly of the belt clip a cross tip
screwdriver is required .
1 . Use a cross tip screwdriver to loosen the
screw of the belt clip
2 . Insert the belt clip on either side of the
product .
3 . Use a cross tip screwdriver to tighten the
screw .
˜ Cleaning and care
m
WARNING!
Always switch the product off, remove
the battery pack
product cool down before performing
inspection, maintenance and cleaning
work!
˜ Cleaning
o
Never allow fluids to get into the product .
The product must always be kept clean, dry
o
and free from oil or grease . Remove debris
from it after each use and before storage .
Regular and proper cleaning will help ensure
o
safe use and prolong the life of the product .
36 GB/IE
5 ]
[
to
9 ]
[
.
10 ]
[
and let the
Clean the product with a dry cloth . Use a soft
o
brush for areas that are hard to reach .
In particular clean the air vents after every
o
use with a cloth and soft brush .
The vents must always be clear .
o
NOTE
u
Do not use chemical, alkaline, abrasive or
other aggressive detergents or disinfectants
to clean this product as they might be
harmful to its surfaces .
˜ Maintenance
Before and after each use, check the product
o
and accessories (e .g . accessory tools) for
wear and damage . If required, exchange
them for new ones as described in this
instruction manual . Observe the technical
requirements (see "Technical data") .
˜ Repair
o
This product does not contain any parts
that can be repaired by the user . Contact
an authorised service centre or a similarly
qualified person to have it checked and
repaired .
˜ Storage
Push the rotation direction switch
o
centre position to lock the on/off switch
Clean the product as described above .
o
o
Store the product and its accessories in a
dark, dry, frost-free, well-ventilated place .
Always store the product in a place that is
o
inaccessible to children . The ideal long term
storage (longer than 3 months) temperature is
between +20 and +26 °C .
Guide the drill bit into the bit holder
o
o
Store the product in its carrying case
Battery pack advice
Only store the battery pack
o
charged . The battery pack should be charged
to 40 to 60 % (red and orange LED in the
14 ]
[
charge indicator
for extended periods .
5 ]
[
to the
6 ]
[
.
8 ]
[
.
19 ]
[
.
10 ]
[
partially
light up) before storing
