Idiomas disponibles
Idiomas disponibles
Large screws, hard materials or removing
o
screws: Select a high level .
For drilling operation: Turn the torque
o
[
3 ]
sleeve
to the
˜ Switching on and off
NOTE
u
The on/off switch
Switching on: Press and hold the on/off
o
[
6 ]
switch
.
Regulate the speed as required (see "Speed
control") (fig . I) .
o
Switching off: Release the on/off
6 ]
[
switch
.
˜ Speed control
By using the on/off switch
o
progressively control the speed:
Pressure
Gentle pressure:
Greater pressure:
˜ LED work light
This product is equipped with a LED work light
to illuminate the immediate working area to
improve visibility in poorly lit areas .
The LED work light
o
as soon as the product is switched on .
NOTE
u
The LED work light
additional approx . 10 seconds after
switching off the product .
˜ Working instructions
Torque
o
Smaller screws/bits can be damaged if you
set the torque or rotational speed too high .
position .
6 ]
[
cannot be locked .
6 ]
[
, you can
Speed
Lower speed
Higher speed
11 ]
[
lights up automatically
11 ]
[
stays on for an
Hard screw joints (in metal)
o
Particularly high torque occurs, for example in
metal screw joints made using drive sockets .
Select a low rotational speed .
Soft screw joints (e.g. in soft wood)
Again, use a low rotational speed, e .g . to
o
avoid damaging the surface of the wood
upon contact with the screw head . Use a
countersink .
Drilling in wood, metal and other
materials
Use a high speed for drill bits with small
o
diameter and a low speed for drill bits with
large diameter .
o
Select a low speed for hard materials and a
high speed for soft materials .
o
Secure or fasten the workpiece in a clamp or
vice (if possible) .
Mark the spot where you want to drill using a
o
centre punch or nail . Select a low rotational
speed when starting .
o
Pull the rotating drill bit from the hole
repeatedly to remove dust and chips and
clear the hole .
Drilling in metal
11 ]
[
Use a metal drill (HSS) . For optimum results,
o
cool the drill bit with cooling lubricant (cutting
oil) . Metal drill bits can also be used to drill
into plastics . Start with a 3 mm diameter drill
bit and then increase the size until the desired
hole diameter is achieved .
Drilling in wood
o
Use a wood drill with a lathe centre .
Deep holes: Use an auger bit .
Large-diameter holes: Use a Forstner bit .
Small screws can be screwed directly into soft
wood .
GB/IE
35
