Idiomas disponibles
Idiomas disponibles
NOTE
u
If you attempt to open the fully opened
[
1 ]
chuck
further, the anti-lock function will
be activated to protect the chuck .
u
When the anti-lock function is activated,
[
1 ]
the chuck
cannot be closed by turning
2 ]
[
the chuck ring
A ratcheting sound will be produced when
you attempt to close the chuck .
u
Deactivating the chuck's
function: Turn the chuck ring
clockwise direction by a certain extent .
Then, turn the chuck ring
quickly in a counter-clockwise direction .
Repeat this action if the anti-lock function
is still active . When the anti-lock function is
deactivated, you should be able to close
[
1 ]
the chuck
without ratcheting sounds .
˜ Trial run
NOTE
u
Always carry out a no-load trial run before
starting work and after every accessory
tool replacement . Switch the product off
immediately if the accessory tool is not
running smoothly, if considerable vibration
occurs or if you hear abnormal noises .
o
Before operating the product, check whether
the accessory tool is correctly positioned, i .e .
centred in the chuck
o
Screw bits are labelled according to their
dimensions and their shape . If you are
uncertain, always check whether the bit fits
tightly in the screw head without any free
play .
34 GB/IE
in a clockwise direction .
1 ]
[
anti-lock
2 ]
[
in a
2 ]
[
suddenly and
1 ]
[
.
˜ Operation
˜ Gear selection
m
ATTENTION! Risk of product
damage!
Do not operate the gear selector
until the product has come to a
standstill .
Change the gear by sliding the gear
o
[
4 ]
selector
forwards or backwards (fig . F) .
1
st
gear:
Suitable for:
Speed:
Torque:
2
nd
gear:
Suitable for:
Speed:
Torque:
˜ Setting the rotating direction
m
ATTENTION! Risk of product
damage!
Do not operate the rotation direction
5 ]
[
switch
until the product has come to
a standstill .
Change the direction of rotation by pressing
o
the rotation direction switch
left or right (fig . G) .
When the rotation direction switch
o
the middle position, the on/off switch
locked .
˜ Torque control
This product is equipped with a torque control that
disengages the spindle when a predefined torque
is exceeded .
The torque can be adjusted by turning the
o
3 ]
[
torque sleeve
(fig . H) .
Small screws or soft materials: Select a low
o
level .
4 ]
[
Screwing
Low
High
Drilling
High
Low
5 ]
[
towards the
[
5 ]
is in
6 ]
[
is
