Setup; Set Temperature Unit; Set Mtc Temperature Value; Set Calibration Standard - OHAUS 3100C Manual De Instrucciones

EN-8
3

SETUP

3.1

Set temperature unit


Power the meter on by pressing

Press and hold
temperature unit blinks. (° C or ° F)

Use or

Press
following or press
Note: ° C = 5/9 (° F -32)
3.2

Set MTC temperature value

After the temperature unit setting, the meter goes to setup manual temperature (MTC) value
setting.
Use or
Press to confirm your setting. Continue with calibration standard setting by following or
press to go back to the measurement screen.
3.3

Set calibration standard

After the MTC temperature value setting, the meter goes to setup calibration standard.
Use or
Press to confirm your setting. Continue with temperature correction coefficient setting
by following or press
3.4

Set temperature correction coefficient

After the calibration standard setting, the meter goes to the temperature correction coefficient
setting.
STARTER 3100C Bench Conductivity Meter
until the set up icon
buttons to select temperature unit .
to confirm your setting. Continue with temperature value setting by
to go back to the measurement screen.
buttons to adjust the temperature value.
buttons to select calibration standard.
to go back to the measurement screen.
.
appears on the display and the current