Setup; System Setup; Ph Setting - OHAUS ST400 Manual De Instrucciones

EN-10
3.2

Setup

3.2.1

System setup

In the measurement mode, long press
mode. Press ▲ button and ▼ button to select the system settings, press
the system settings.
User ID， the system allows a maximum of 5 user IDs.(less than 8-Bit characters, it can be
numbers or uppercase or lowercase letters), press ▲ button and ▼ button to select the desired
user ID you want to set, long press
select between uppercase letters, numbers and lowercase letters, press
current selection, it will automatically jump to the next character. When the settings are completed,
press the button to confirm the settings and return to the parameter settings.
Sample ID, the system can set up to five sample IDs (less than 8-bit characters, which can be
numbers or uppercase letters or lowercase letters). The user can change the ID according to the
method mentioned above.
Language, system is built-in with six languages (English, German, French, Spanish, Italian,
Chinese), press ▲ button and ▼ button to select, press
Date and Time, press ▲ button and ▼ button to change the time and date, date format, time
format.
Backlight, press ▲ button and ▼ button to select between Low, Medium, High, Off. Press
to confirm.
Beep, press ▲ button and ▼ button to select on or off.
Auto power off, press ▲ button and ▼ button to select on or off. When auto power off is on, the
meter will automatically shut down when no operation in 15 min (Not in continuous measurement
mode).
3.2.2

pH Setting

In the setup mode, press ▲ button and ▼ button to select pH settings, press
pH settings. There are the following settings:
Temperature compensation (ATC automatic temperature compensation or MTC manual
temperature compensation); the electrode with built-in temperature probe is recommended, If you
use 2-in-1 electrode to measure pH, it is recommended to work with a temperature probe.
Unnecessary measurement errors can be avoided in the ATC mode.
ST400 & ST400M Portable Meter
button (more than 3 seconds) to enter the setup
,the cursor blinks, press ▲ button or ▼ button to
to confirm.
button to enter
to confirm the
to enter the